To avoid personal injury and/or damaging the injection/ignition system, proceed as follows: |
t
| Do no touch or remove the ignition wiring with the engine or ignition on. |
t
| Remove and connect the injection/ignition system wires, including measurement equipment leads, only when the ignition is off. |
If test and measurement equipment is needed during a road test, the following must be taken into account: |
t
| Always install test and measurement equipment in the rear seat and have a second mechanic operate them from there. |
If test and measurement equipment is operated from the front passenger seat, the operator could be injured by the airbag in the event of an accident. |
t
| To turn over the engine without it starting up: |
–
| Remove the air filter → Fig. |
|
|
|