Leon Mk1
|
1 - | All-wheel drive control unit -J492- |
q | Calibrated with coupling opening control valve -N373- → Item. |
q | Always renew together with valve → Item |
q | Removing and installing → Chapter>>>>>>>> |
2 - | Bolt, 6 Nm |
3 - | Cap |
q | With vulcanised seal |
q | Always replace. |
4 - | Coupling opening control valve -N373- |
q | Calibrated to match four-wheel drive control unit -J492- |
q | Always renew together with control unit → Item |
5 - | Seal |
q | »Modified« version with diagonally located centring lips |
q | Replaces the seal → Item. |
q | Observe proper seating of centring lips in the groove |
q | Moisten with high performance oil for Haldex clutches and install |
q | Always replace. |
6 - | Seal |
q | »Old« version |
q | The »modified« version is included in the seal set → Item |
7 - | Seal |
q | Diameter 12 mm |
q | For the valve that controls the opening of the clutch -N373- |
q | Moisten with high performance oil for Haldex clutches and install |
q | Always replace. |
8 - | Seal |
q | Diameter 11 mm |
q | For the valve that controls the opening of the clutch -N373- |
q | Moisten with high performance oil for Haldex clutches and install |
q | Always replace. |
9 - | Seal |
q | With oil pressure and oil temperature sender -G437- |
q | Moisten with high performance oil for Haldex clutches and install |
q | Always replace. |
10 - | Oil pressure and oil temperature sender -G437- |
q | Can be re-used when renewing control unit |
11 - | Dished spring |
q | In the installation position, the mark -arrow- must point up towards the pressure sensor → Fig. |