Leon Mk1
|
1 - | Bolt. |
q | Tightening torque: 10 Nm |
2 - | Speed sensor |
q | Left and right parts are identical |
q | removing and fitting → Chapter |
q | Connector for speed sensor → Chapter |
q | Before fitting the sender, clean the inner surface of the hole and apply solid lubricant paste according to the → Parts catalogue. |
q | Insert into wheel bearing housing up to stop. |
3 - | Drive shaft with rotor |
q | Check whether rotor is not damaged or dirty → Anchor |
q | If rotor is damaged, outer C.V. joint must be renewed together with rotor → Rep. gr.40 |
q | As replacement part, outer C.V. joint is supplied together with rotor. |
4 - | Cable for speed sensor |
q | Install into mounts intended for this purpose |
5 - | Bolt. |
q | Always replace |
q | Different versions → Parts catalogue |
Vehicle must be standing on the ground when tightening |
Tightening torques: → Running gear, axles, steering; Rep. gr.40 |