Leon Mk1
ABS Bosch 5.7 (ABS/EDS/ASR/ESP) |
Note
All components marked with 1) can be checked using the vehicle diagnostic, measuring and information system -VAS 505X - in “Guided fault finding”. |
1 - | ABS control unit -J104-1) |
q | removing and fitting → Chapter. |
2 - | ABS hydraulic unit -N55-1) |
The hydraulic unit consists of the following components: |
q | ABS hydraulic pump -V64- |
q | Remove the ABS control unit -J104- and the ABS hydraulic unit -N55- → Chapter. |
3 - | Brake pressure sender 1 -G201-1): |
q | Only for vehicles with ABS/EDS/ASR/ESP |
q | removing and fitting → Chapter. |
4 - | Brake servo / Master brake cylinder |
q | Assembly overview → Chapter |
5 - | TCS and ESP button -E256- |
q | Installation location: In centre console |
q | Only for vehicles with ABS/EDS/ASR/ESP |
6 - | Stability Program Indicator, ASR/ESP -K155- |
q | Operation: → Chapter |
7 - | ABS warning lamp -K47- |
q | Operation: → Chapter |
8 - | Handbrake indicator light -K14- |
q | Operation: → Chapter |
9 - | Steering wheel angle sender -G85-1) |
q | Installation location: at the steering column between the steering wheel and the steering column switch. |
q | removing and fitting → Chapter. |
10 - | Diagnostics connection |
q | Installation location: In driver's storage compartment |
11 - | Revolution sensor for the rear right hand wheel -G44- and Revolution sensor for the rear left hand wheel -G46-1) |
q | Removal and fitting, vehicles with disc brakes → Chapter |
q | Removal and fitting, vehicles with drum brakes → Chapter |
12 - | Rear wheel housing with bearing and sensor ring |
q | Sensor ring integrated into bearing oil seal |
q | Removing and fitting → Running gear, axles, steering; Rep. Gr.42 |
13 - | Transversal acceleration sender -G200- and yaw rate sender -G202-1) |
q | They are installed in an enclosure |
q | Installation location: at the cross-beam of the left front seat on the floor panel |
q | removing and fitting → Chapter. |
14 - | Brake light switch -F- and brake pedal switch -F47- |
q | In rest position it is open |
q | removal, installation and adjustment → Chapter |
15 - | Front wheel housing with bearing and sensor ring |
q | Sensor ring integrated into bearing oil seal |
q | Removing and fitting → Running gear, axles, steering; Rep. Gr.40 |
16 - | Revolution sensor for the front right hand wheel -G45- and Revolution sensor for the front left hand wheel -G47-1) |
q | removing and fitting → Chapter. |