–
| Disconnect connector -1- from revolutions sensor cable. |
–
| Remove bolt -2- from the wheel bearing casing. |
–
| Remove the ABS rev. sensor upwards. |
–
| Before fitting the revolution sensor the inside surface of the opening must be cleaned and the sensor must be lubricated completely with → Parts catalogue. |
–
| Insert revolution sensor in opening in the steering knuckle and tighten bolt to 8 Nm. |
–
| Connect connector for revolution sensor. |
–
| Turn steering wheel fully in both directions and check that rev. sensor cable is able to move freely. |
|
|
|