seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
ESP system components: removing and fitting > < Removing and installing parts of ABS system on front and rear axles

Leon Mk1

Rear axle rev. sensor: removal and installation
Rear axle rev. sensor: removal and installation
Removal
Commercial vehicles
–  Partially separate the front part of the lining carpet in the loading area.
   
–  Extract the lower panels -1- from the dividing wall.
–  Remove the forward linings -2-.
–  Extract underbody protection plates -3-.
Kombi vehicles
–  Move rear seat forward.
Continued for all vehicles
  E20-0068
–  Disconnect connector -arrow- for rev.sensor.
–  Raise the vehicle.
  N45-0103
–  Unscrew bolt -arrow 1- for rev.sensor.
–  Remove rev. sensor from wheel stub and brake back plate.
–  Loosen the rev. sensor cable from the leaf spring suport fixing clamp -arrow 2-.
  E45-0021
–  Unclip the rear axle cable bar/cable securing guide -1-.
–  Separate the rev. sensor cable from the cable bar/cable securing guide.
–  Unclip from supports -2- and from sleeve -3- and remove rev.sensor from inside vehicle.
Installation
–  Before fitting the rev.sensor the inside surface of the opening must be cleaned and the sensor must be lubricated with -G 000 650- lubricating paste.
–  Install in reverse order.
  E45-0022

ESP system components: removing and fitting > < Removing and installing parts of ABS system on front and rear axles