Remove securing bolts from brake calliper housing, when doing this counter-hold on guide pins.
–
Pull out retaining clip -1- and unhook handbrake cables at brake calliper.
–
Remove the brake calliper housing and place it so that the weight of the brake calliper does not rest on or damage the flexible tube of the brake.
WARNING
Do not leave brake calliper hanging from brake hose but secure it to bodywork using a suitable cable tie or wire. Take care that brake hose is not damaged by weight of brake components.
Do not apply brake when brake calliper is removed.
Note
If you are going to use the brake pads again, mark them when you remove them. Put them back in the same positions, otherwise, the braking effect will not be even.
–
Remove the brake pads .
–
Remove guide clips.
Note
Push brake piston into cylinder with resetting tool before inserting brake pads. Before pressing the piston back, draw off brake fluid from the reservoir with a bleeder bottle. Otherwise, fluid can overflow and cause damage, particularly if reservoir has been topped up.
–
Screw in piston by turning piston compressing and extracting tool - 3272 - clockwise.