Leon Mk1
Note
|
1 - | Brake back plate |
q | Tighten with the brake calliper housing |
2 - | Guide pin, 30 Nm |
3 - | Hoods |
q | Insert into sleeve bearing. |
4 - | Protective cap |
q | Push on the bleeder screw |
5 - | Bleeder valve, 15 Nm |
q | Before tightening, apply a fine layer of assembly paste to the screw thread → Spare parts catalogue. |
6 - | Mounting bush |
q | Fit into the brake calliper housing |
7 - | Housing for brake calliper |
8 - | Retaining spring |
q | Ensure for the correct installation position |
q | Engage onto both brake calliper housing studs and onto outer pad retaining spring. |
9 - | Protective cap |
q | Take care not to damage when inserting piston. |
q | Apply a fine layer of assembly paste → Spare parts catalogue |
10 - | Piston |
q | Apply a thin coating of assembly paste → Spare parts catalogue to the piston beforehand. |
11 - | Seal |
q | Apply a fine layer of assembly paste → Spare parts catalogue |