Checking pressure and adjustment |
The braking force regulator is adjusted with the vehicle at curb weight → Note. |
–
| Place the block on the brake pedal. |
–
| Raise the vehicle and connect the pressure gauge to the brake calliper (front left wheel) and the wheel brake cylinder/brake calliper (rear wheel right). |
–
| Lower vehicle and bounce it several times at the rear axle. |
–
| Remove the block from brake pedal. |
–
| Apply pressure to brake pedal and measure pressures. |
–
| Compare the measured pressure values with the adjustment values → Chapter. |
–
| If necessary, adjust the braking force regulator → Chapter. |
1)
| The kerb weight is defined as: The weight of the vehicle ready for use including: a driver weighing 75 kg, fuel tank and a full plenum chamber for windscreen and headlight cleaning, spare wheel, and on-board tools and jack in their corresponding locations. |
|
|
|