Leon Mk1
FN 3 brake calliper - general assembly overview |
1 - | Rubber cap |
2 - | Bleeder screw |
q | 10 Nm |
q | Before tightening, apply a fine layer of assembly paste to the screw thread → Spare parts catalogue. |
3 - | Hoods |
q | Fit them into the bush bearing |
4 - | Guide pin |
q | 30 Nm |
5 - | Mounting bush |
q | Fit it into the brake calliper housing |
6 - | Housing for brake calliper |
7 - | Brake back plate |
q | Tighten with the brake calliper housing |
8 - | Retaining spring |
q | Hook into the two holes in the brake calliper housing |
9 - | Seal |
q | Do not damage protective cover when fitting the piston |
q | removing and fitting → Chapter. |
10 - | Piston |
q | removing and fitting → Chapter. |
q | Apply a thin coating of assembly paste to the piston → Spare parts catalogue |
11 - | Rubber cap |
q | Fit with the outer sealing lip on the piston |
q | Do not damage protective cover when fitting the piston |
q | removing and fitting → Chapter. |