Leon Mk1
Lucas brake calliper - assembly overview |
1 - | Dust cap |
2 - | Vent valve |
10 Nm |
q | Before tightening, lightly grease the thread with assembly paste → Parts catalogue |
3 - | Housing for brake calliper |
4 - | Hexagonal nut |
q | 30 Nm |
q | To tighten and loosen, block the guide pin |
q | Replace |
5 - | Seal |
q | removing and fitting → Chapter. |
6 - | Piston |
q | removing and fitting → Chapter. |
q | First apply a thin coating of assembly paste → Parts catalogue |
q | Piston diameter 54mm |
7 - | Protective cover |
q | removing and fitting → Chapter. |
q | Do not damage protective cover when fitting the piston |
8 - | Heat shield |
q | Fit over piston |
9 - | Brake holder with different guide bolts and protective hoods |
q | Delivered as assembled part, with sufficient lubrication on the guide pins |
q | If the protective covers or the guide pins have been damaged, fit the whole repair unit. Use the attached grease to lubricate the guide pins |