Leon Mk1
FS III brake calliper - general assembly overview |
1 - | Dust cap |
2 - | Vent valve |
q | 10 Nm |
q | Before tightening, lightly grease the thread with assembly paste → Parts catalogue |
3 - | Caps |
q | Fit them into the bush bearing |
4 - | Guide pin |
q | 28 Nm |
5 - | Mounting bush |
q | Fit it into the brake calliper housing |
6 - | Housing for brake calliper |
7 - | Protective cover |
q | removing and fitting → Chapter. |
q | Do not damage protective cover when fitting the piston |
8 - | Piston |
q | removing and fitting → Chapter. |
q | First apply a thin coating of assembly paste → Parts catalogue |
9 - | Seal |
q | removing and fitting → Chapter. |