t
| If the ABS warning lamp -K47--1- does not go out after switching ignition on and completion of test sequence then the fault may be: |
-a- Voltage supply is below 10 Volt. |
-b- There is a fault in the ABS. |
Caution The anti-lock brake system remains switched off with an ABS fault -b-, but the brake system remains fully operational. |
|
-c- Since the last time the vehicle was started there was a temporary speed sensor fault. |
In this case the ABS warning lamp will go out automatically after the engine is restarted and the vehicle exceeds a speed of 20 km/h. |
ABS warning lamp -K47- and brake system warning lamp -K118- |
t
| If the ABS warning lamp -K47--1- goes out but the brake system warning lamp -K118--2- remains on then the fault may be: |
-a- The handbrake is applied. |
-b- The brake fluid level is too low. |
t
| If the ABS warning lamp -K47--1- and the brake system warning lamp -K118--2- light up then the ABS is defective. A change in braking behaviour is to be reckoned with. |
Caution After the ABS warning lamp -K47- and the brake system warning lamp -K118- have lit up it is possible that the rear wheels will lock-up earlier. |
|
|
|
|