SEAT Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Front wheel brake: repairing >
< Repairing rear brakes
Leon Mk1
Running gear
Brake systems
Brake, brake mechanics
Hand brake cable: removal and fitting (vehicles with disc brakes)
Hand brake cable: removal and fitting (vehicles with disc brakes)
Hand brake cable: removal and fitting (vehicles with disc brakes)
Removing
–
Release hand brake.
–
Dismounting the center console:
→ General body repairs, assembly work, interior; Rep. Gr.68
.
–
Loosen readjusting nut
-arrows-
sufficiently to disconnect the hand brake cable from the expansion tab.
–
Raise the vehicle.
–
Remove wheel.
–
Securing pin
-1-
remove.
–
Push hand brake
-2-
in the direction of the arow and release the hand brake cable
-3-
.
–
Release the brake cable from the control support on the rear axle body
-arrow A-
and unhook it from the support
-arrow-
.
–
Remove the hand brake cable
-1-
from the guide tube by pulling it in the direction of the arrow.
Installation
–
Insert the hand brake cable into the guide tube.
–
Push hand brake
-2-
in the direction of the arrow and release the hand brake cable
-3-
.
–
Securing pin
-1-
fit.
–
Connect hand brake cable to its support in the body of rear axle
-arrow A-
.
–
The hand brake securing ring must be in the centre of the pin.
–
Connect hand brake cable to the support
-arrow-
.
–
Connect hand brake cable the expansion tab.
–
Pretension the cable using the adjusting nuts
-arrows-
.
–
Adjust hand brake
→ Chapter
.
Running gear
Brake systems
Brake, brake mechanics
Hand brake cable: removal and fitting (vehicles with disc brakes)
Front wheel brake: repairing >
< Repairing rear brakes