–
| Clean the surfaces of the piston and ring gaskets with alcohol only and then dry. |
–
| Cover the surface of the piston and ring gasket with a thin layer of -G 052 152 A2- paste before fitting them. |
–
| Insert the sealing O-gasket inside the groove of the cylinder using wedge -U-30800-. |
–
| Fit the outside sealing protective cover over the piston. |
–
| Carefully fit the piston to its corresponding cylinder in the brake clip housing. |
–
| Tighten the brake piston with tool -T20121- to attach it to its cylinder. |
–
| In the course of this operation the outside seal falls into the slot in the brake clip. |
|
|
|