SEAT Workshop Service and Repair Manuals > Leon Mk1 > Running gear | Running gear, axles, steering | Front suspension, drive shafts | Articulated half-shaft. | Dismantling and assembling drive shaft with VL90 or VL100 constant velocity joint

Dismantling

Removing outer constant velocity joint

–	Separate the dustguard of the constant velocity joint with a punch.

–	Fit the extractor -T20181- on the neck of the drive shaft and rotate the bolt on the constant velocity joint until it is released from the complete half-shaft.

For constant velocity joint VL107

–	Separate the cover from the constant velocity joint using an awl.

Driving off cover from inner joint

Continue for all the constant velocity joints

–	Remove circlip.

–	Remove both clamps and slide boot towards outer joint.

Pressing off inner constant velocity joint

SEAT Workshop Service and Repair Manuals