SEAT Workshop Service and Repair Manuals > Leon Mk1 > Running gear | Running gear, axles, steering | Front suspension, drive shafts | Articulated half-shaft. | Intermediate shaft - Remove and install, repair

Installation

–	First replace the seal -1- of the gearbox.

–	Fit the intermediate axle on the corresponding shaft of the gearbox until the bearing -2- is supported, »without leaving any aperture«, on the support bracket -1--arrow-.

–	Tighten the bolts -arrows- to the correct torque.

–	Fit the drive shafts → Chapter.

Specified torques

Component	Tightening torque
Intermediate shaft bearing to bearing bracket	20 Nm

SEAT Workshop Service and Repair Manuals