SEAT Workshop Service and Repair Manuals > Leon Mk1 > Running gear | Running gear, axles, steering | Front suspension, drive shafts | Articulated half-shaft. | Intermediate shaft - Remove and install, repair

repairs

Special tools and workshop equipment required

t	Clamping tool -T20149-

t	Tool set -U-40450A-

Release the bearing

–	Release the bearing from the intermediate shaft as shown in the figure.

–	Fit the pressure tool -T20149/1- between the socket and complete half-shaft flange.

Insert the bearing

–	Insert the bearing into the intermediate axle as far as possible, as shown in the figure.

–	Insert the pressure tool -T20149/1- below the bearing in such a way as to support it in the groove, the bolts are facing the driveshaft flange.

SEAT Workshop Service and Repair Manuals