seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removal: > < Loosening and tightening twelve-point head bolt, without ribbing, securing drive shaft

Leon Mk1

Removing and installing drive shafts
Removing and installing drive shafts
Loosening and tightening drive shaft hexagon bolt → Chapter.
Loosening and tightening twelve-point head bolt, with ribbing, securing drive shaft → Chapter.
Loosening and tightening twelve-point head bolt, without ribbing, securing drive shaft → Chapter.
→ Chapter „Removal:“
→ Chapter „Installation“
→ Chapter „Remove the driveshaft with → tripod type joint AAR2600i“
→ Chapter „Fit the driveshaft with → tripod type joint AAR2600i“
  WARNING
When carrying out disassembly and assembly work on the vehicle, the articulated half-shafts should not be left hanging, nor should they be bent too far in order to fit them in the joint.
   
Consult the equivalence table for tools and equipment according to applicability between Seat / VW / Audi / Skoda → Chapter.
Special tools and workshop equipment required
t  Pulling device -T20001A-
t  Torque wrench -V.A.G 1332-, see equivalence → Anchor
t  Angle wrench -V.A.G 1756-

   

Removal: > < Loosening and tightening twelve-point head bolt, without ribbing, securing drive shaft