SEAT Workshop Service and Repair Manuals

Torque settings

Ball joint fixing in the bush bearing Use new nut	35 Nm
Front bolt of swinging arm -1- Use new bolts	70 Nm +1/2 turn (180º)
Rear bolt of swinging arm -2- Use new bolts	70 Nm +1/2 turn (180º)
Vehicle with mechanical steering Steering box bolt -3- Use new nuts.	20 Nm +1/4 turn (90º)
Vehicle with power steering Steering box bolt -3- Use new nuts.	20 Nm +1/4 turn (90º)

Fit the supports of the engine assembly without tensing them: → Rep. Gr.10. –  Following the assembly of the subframe, verify the steering wheel position and the vehicle alignment. Vehicles with cable gear change

–  Fit the cable connection support, gear controls to the subframe -arrow-.

Tightening torques:
Attachment of the support to the subframe	15 Nm

–  Secure the pendular support to the gear box

Tightening torques:
Bolt -1-
Nut -2- Replace after removing	50 Nm +1/4 turn (90º)
Nut -3- Replace after removing	20 Nm +1/4 turn (90º)