Leon Mk1
| Rear axle: Assembly overview |
Note| t | It is not permitted to weld or straighten load-bearing or wheel-guiding components of the suspension. |
| t | Always replace self locking nuts following their removal. |
| t | Always renew corroded nuts and bolts. |
| t | Bonded rubber bushes can only be turned to a limited extent. Therefore, tighten the bolted connections of components with bonded rubber bushes only when the wheel bearing housing has been raised (unladen state) → Chapter. |
| t | Always renew bonded rubber bush on both sides of the vehicle. |
| I - | Assembly overview: Subframe (front-wheel drive) → Chapter |
| II - | Assembly overview: Transverse link, track rod (front-wheel drive) → Chapter |
| III - | Assembly overview: Wheel bearing housing, trailing arm (front-wheel drive) → Chapter |
| IV - | Assembly overview: Shock absorber, coil spring (front-wheel drive) → Chapter |
| V - | Stabiliser (front-wheel drive) - Assembly overview → Chapter |