| Changing from wheel housing bearing made from cast steel to wheel bearing housing made from aluminium |
| Changing from wheel housing bearing made from cast steel to wheel bearing housing made from aluminium has been implemented. Only wheel bearing housings made from aluminium are available as replacement parts. Therefore, certain parts have to be exchanged and/or installed in addition when replacing → Electronic parts catalogue „ETKA“. |
| The following parts have to be renewed and/or installed in addition: |
| t
| Bolts (qty. 2) for backing plate |
| t
| Bolt, nut and washer for top control arm to wheel bearing housing |
| t
| Bolt, nut and washer for track rod to wheel bearing housing |
| t
| Bolt and washer for shock absorber to wheel bearing housing |
| t
| Bolts (qty. 2) for trailing link to wheel bearing housing |
| t
| Cover plate with bolts (qty. 4) to wheel bearing housing |
Caution | The additional washers that have to be installed must always be placed between the component and the wheel bearing housing. |
| Installing a wheel bearing housing made from aluminium on one side of the vehicle and a wheel bearing housing made from cast steel on the other is permissible → Electronic parts catalogue„ETKA“. |
|
|
|
|
