SEAT Workshop Service and Repair Manuals > Leon Mk1 > Running gear | Running gear, axles, steering | Rear suspension, drive shaft | Wheel bearing housing, trailing link (four-wheel drive, subframe made from aluminium and wheel bearing housing made from cast st | Renewing bonded rubber bush for wheel bearing housing

Wheel hub and bearing assembly: removing and fitting > < Pressing in bonded rubber bush

Installation

Installation is carried out in the reverse sequence; note the following:

The steering knuckle may only be bolted when having the elevation measured prior to assembly, between the centre of the wheel hub and the lower rim of the wheel housing → Chapter.

Specified torques

Component

Tightening torque

Steering knuckle to lower transversal swinging arm

t	Use new nuts and bolts

t	Tighten threaded connections only when vehicle is in the normal running position

90 Nm + 90°

Splash plate to wheel bearing housing

10 Nm

Brake disc to wheel bearing housing

4 Nm

Running gear
Running gear, axles, steering
Rear suspension, drive shaft
Wheel bearing housing, trailing link (four-wheel drive, subframe made from aluminium and wheel bearing housing made from cast st / newing_bonded_rubber_bush_for_wheel_bearing_housing/">Renewing bonded rubber bush for wheel bearing housing
Installation

Wheel hub and bearing assembly: removing and fitting > < Pressing in bonded rubber bush