Leon Mk1
|
1 - | Wheel bearing housing |
q | removing and fitting → Chapter |
q | The preseal -arrow- should not rub against the wheel bearing/wheel hub. |
q | Do not remove additional seal |
2 - | Guard plate |
3 - | Wheel bearing/wheel hub unit |
q | Does not always have to be renewed |
q | If the wheel bearing/wheel hub can be pulled out manually from the wheel bearing housing, the wheel bearing is okay and can be reused. |
q | If it is not possible to pull out manually, replace wheel bearing/wheel hub. |
q | Always replace completely |
4 - | Bolt. |
q | → Item, |
q | Always replace. |
5 - | Torx screw |
q | Tightening torque: 10 Nm |
6 - | Bonded rubber bush |
q | Pressing off → Fig. |
q | Pressing on → Fig. |
Note
|
Note
|
|