seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Wheel alignment > < Tightening torques for wheel bolts

Leon Mk1

Renewing bottle with tyre sealant
Renewing bottle with tyre sealant
Removing
–  Unclip the housing on the lower part of the retainer and pull the housing upwards.
   
–  Turn the bottle counter-clockwise and remove it from the retainer.
  N44-0164
–  Unscrew the knurled nut -arrow- from the bottle for the hose leading from the compressor to the bottle.
–  Dispose of the bottle → Chapter
Installing
  N44-0165
–  Carefully place the knurled nut on the thread -1- and tighten it by hand.
Ensure that the knurled nut does not cant on the thread -1-!
–  Insert new bottle with tyre sealant into retainer.
  N44-0166
–  Turn bottle clockwise onto stop.
–  Secure hose -arrow A- in the hose guide.
–  Roll up cable with connector for compressor power supply and place it in the recess under the pressure gauge.
–  Fit housing.
–  Roll up the hose with tyre inflating connection and place it in the housing recess.
  N44-0167
–  Stick the new sticker from the repair kit on the housing -arrow-.
  N44-0168

Wheel alignment > < Tightening torques for wheel bolts