seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Adapting components, headlights with gas discharge bulbs > < Removing and installing rear left vehicle level sender G76 on rear axle

Leon Mk1

Removing and installing headlight range control motor
Removing and installing headlight range control motor
  Note!
The control motor can only be removed and installed when the headlight housing has been removed.
  Warning
If control motors are removed and installed or renewed, after reinstallation the basic setting of the headlight must be carried out → Chapter.
Removing:
–  Switch off ignition and all electrical consumers and remove ignition key.
–  Remove headlight → Chapter.
   
–  Remove bolt -arrow- and remove sealing cover.
  Note!
The sealing cover is secured with one or two screws, depending on the manufacturer of the headlight.
  N94-0504
–  Unscrew both securing bolts -arrows- on outside of housing.
–  Pull adjustment shaft ball head out of mounting on reflector.
–  Remove headlight range control motor and disconnect connector on control motor.
Installing:
–  Reconnect connector.
  N94-0486
–  Guide adjustment shaft of control motor into ball head mounting -arrow-, hold reflector base plate up through opening in headlight for this.
–  Disconnect headlight range control motor connector -6-.
–  Fit sealing cap.
–  Install headlight → Chapter.
–  Adjusting headlights with gas discharge bulb → Chapter.
  N94-0487

Adapting components, headlights with gas discharge bulbs > < Removing and installing rear left vehicle level sender G76 on rear axle