| Tightening order: Bracket for auxiliary units on the cylinder block |
| –
| Fit the bracket for the ancillary units onto the cylinder block. |
Note | t
| Position all the bolts before tightening to prescribed torques. |
| t
| The tightening torques listed on this page apply only to lightly greased, oiled, phosphated, or black-finished nuts and bolts. |
| –
| Tighten the securing screws of the bracket for ancillaries in the following order: |
| A - | Hexagonal bolt with collar, M10 x 45, 40 Nm |
| B - | Hexagonal bolt with collar, M10 x 45, 40 Nm |
| C - | Hexagonal bolt with collar, M10 x 45, 40 Nm |
| D - | Hexagonal bolt with collar, M10 x 45, 40 Nm |
| E - | Hexagonal bolt with collar, M10 x 45, 40 Nm |
| F - | Hexagonal bolt with collar, M10 x 45, 40 Nm |
|
|
|
