SEAT Workshop Service and Repair Manuals

Removal: –  Remove battery → Chapter.

Vehicles with 1.6 litre 2-valve engine –  Disconnect hoses -1- and -2- from air cleaner housing. –  Unscrew the bolt -3-. –  Take out air cleaner housing.

Vehicles with 2.0 litre FSI engines: –  Remove connector -4- for intake air temperature sender -G42- in air filter housing. –  Disconnect hoses -1- and -2- from air cleaner housing. –  Unscrew the bolt -3-. –  Take out air cleaner housing.

Vehicles with TIDE engine –  Unplug connector -2- at air-mass meter -G70-. –  Detach vent hose -1- and air ducts -3- and -5-. –  Screw out bolt -4- and detach air cleaner housing.

All: –  Remove battery tray -arrows-. –  Detach battery tray from air duct at front.

–  Remove 6-contact relay carrier from below electrical device servicing socket in engine compartment -arrow-.

–  Release 6-contact relay carrier cover -arrows-.

–  Release clips -arrows- ...

–  ... and remove 6-contact relay carrier -arrow- from cover.   Note

The exact location of the 6-contact relay carrier below the electrical device servicing socket in the engine compartment must always be consulted in the current circuit diagram → Current flow diagrams, Electrical fault finding and Fitting locations.