SEAT Workshop Service and Repair Manuals

Removal: –  Remove battery → Chapter.

Vehicles with 1.6 litre 2-valve engine –  Disconnect hoses -1- and -2- from air cleaner housing. –  Unscrew the bolt -3-. –  Take out air cleaner housing.

Vehicles with 2.0 litre TDI engine –  Unplug connector -2- at air-mass meter -G70-. –  Detach vent hose -1- and air ducts -3- and -5-. –  Screw out bolt -4- and detach air cleaner housing. Both sides (continued):

–  Remove battery → Chapter. –  Remove battery tray -arrows-. –  Detach battery tray from air duct at front.

Vehicles with 2- valve 1.6 litre or TDI 2.0 litre engine –  Remove 6-contact relay carrier from below electrical device servicing socket in engine compartment -arrow-.

All: –  Press retaining clips in -direction of arrow- and remove cover from electrical device servicing socket in engine compartment.

–  Release fasteners -arrows- and lift off the cover of the electronics box -1-. –  Open the cover -2- of the cable guides in the electronics box -arrows-. –  Remove cables from the connection rods. –  Remove cables from the guides.

–  Unscrew bolt -arrow-. –  Remove relay carrier and fuse holder from electrical device servicing socket in engine compartment.

–  Unplug 26-contact connector -1- and 40-contact connector -2- in electrical device-servicing socket in engine compartment.

–  Unscrew nuts -1- and -2-. –  Pull electrical device servicing socket in engine compartment upwards -3-.   Note

The exact location of the electrical device servicing socket in the engine compartment must always be consulted in current circuit diagram → Current flow diagrams, Electrical fault finding and Fitting locations.