seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

Emergency braking function > < Washer fluid lines
Removing and installing steering column switch module (SCSM)
Removing and installing steering column switch module (SCSM)
Special tools and workshop equipment required
   
t  Torque wrench -V.A.G 1331-
  W00-0427
t  Torque wrench -V.A.G 1783-
  Note
t  For removal and installation of the airbag coil connector and return spring with slip ring -F138- or the steering column switch, the steering wheel must be in the „centre position“ (wheels in „straight ahead position“).
t  The airbag coil connector and return spring with slip ring -F138- is not to be moved out of position.
t  If the steering angle sender -G85- is integrated into the airbag coil connector and return spring with slip ring -F138- (vehicles with ESP = Electric Power Steering), the steering angle sender must be reset after work has been done on the steering column switch.
Removing:
–  Disconnect battery . → Chapter
–  Turn steering wheel to „centre position“ (wheels in „straight ahead position“).
–  Remove steering wheel → Running gear, axles, steering; Rep. gr.48.
–  Move the steering column to its lowest position by means of the steering column adjustment feature and lock it in place with the locking lever.
–  Remove steering column trim → General body repairs, interior; Rep. gr.68
  W00-0990
–  Release securing bolt -arrow- of steering column switch -1-.
  N94-10354
–  Pull safety latch -2- upwards in -direction of arrow B- and pull connector -1- off steering column switch -3-.
–  Pull steering column switch -3- towards the rear and off steering column.
Installing:
Install in the same way but in reverse order of removal. When doing this, note the following:
–  If the steering angle sender -G85- is integrated into the airbag coil connector and return spring with slip ring -F138- (vehicles with ESP = Electric Power Steering), reset the steering angle sender.
  N94-10355

Emergency braking function > < Washer fluid lines