Leon Mk2
| Assembly diagram |
Note!| t | Disconnect the battery earth strap |
| t | In vehicles with coded radio, consult the code before disconnecting the battery earth strap |
| t | Lubricate the points of support and the sliding surfaces with -G 052 142 A2- grease |
| 1 - | Support |
| q | First remove the steering column before removing the bracket. → Running gear, axles, steering; Rep. Gr.48 |
| q | Separate brake pedal from brake main cylinder → Brake system; Rep. Gr.46 |
| 2 - | Hexagon bolt |
| q | 25 Nm |
| 3 - | Hexagonal nut, self-locking |
| q | 25 Nm |
| q | 5 units |
| q | To fix the bracket to the brake servo |
| 4 - | Support |
| 5 - | Hexagon bolt |
| q | 25 Nm |
| 6 - | Safety catch |
| q | Removing and fitting → Chapter |
| 7 - | Brake and clutch pedal shaft |
| q | Assembly position: the recess -arrow- should be facing the clutch pedal side |
| 8 - | Bearing bush |
| q | For locating the steering column |
| 9 - | Brake pedal |
| 10 - | Cap |
| 11 - | Clutch pedal |
| q | Removing and fitting → Chapter |
| 12 - | Safety catch |
| q | Removing and fitting → Chapter |
| 13 - | Support |
| q | For the clutch cable |
| 14 - | Clutch cable |
| q | With automatic adjustment |
| q | Assign according to the Spares Catalogue |
| q | Checking functioning → Chapter |
| q | Removing and fitting → Chapter and → Chapter |
| 15 - | Clutch cable |
| q | Without automatic adjustment |
| q | Assign according to the Spares Catalogue |
| q | Removing and fitting → Chapter |
| q | Adjusting → Chapter |
| 16 - | Clutch cable adjustment nut |
| q | Secure with the counter nut after adjusting |
| 17 - | Return spring |
| q | Do not fit if a clutch cable with automatic adjustment is used |
| 18 - | Bellows |
| q | Fit to the wall of the bulkhead |