seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Selector lever cable: adjustment > < Selector lever cable: removing and installing|Installation

Leon Mk2

Selector lever cable: checking
Selector lever cable: checking
  Note
t  Cleaning norms when working in the gearbox → Chapter.
t  General repair instructions → Chapter.
  Note
All cable clamps that become loose or cut when removing must be re-installed in the same place when installing.
Brief description
To check whether the selector lever cable operates smoothly, disconnect it from the gearbox and place the end so that it does not rub against anything.
Then move the selector lever and remount the cable.
Next, adjust the cable → Chapter.
–  Put the gear selector lever into position “P”.
   
–  Remove the selector cable -1- from the selector rod -3- by levering with an open-end wrench -2-.
–  Remove the control cable from the counter support by pressing the tabs -arrows-.
–  Move the selector lever from position “P” to position “S” several times.
l  The selector lever should move smoothly.
–  Remount the selector cable.
–  Adjusting the selection cable → Chapter
  A37-0577

Selector lever cable: adjustment > < Selector lever cable: removing and installing|Installation