seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Remove and install bearing bracket and master cylinder|Installation > < Remove and install bearing bracket and master cylinder

Leon Mk2

Removing
Removing
For those vehicles with an anti-theft code radio, the code must be found before removing the battery.
–  Disconnect earth wire at battery with ignition switched off.
–  Remove engine cover. → Booklet2
–  Remove air filter housing; gasoline engines → Rep. Gr.24 and diesel engines → Rep. Gr.23.
   
–  Clamp the return hose -A- with the clamp -U 30042-.
–  Carefully extract the hose -A- going to the brake fluid tank.
–  Using screwdriver -1-, remove retaining clip -B- that holds pipe and hose -C-to the clutch master cylinder.
  E30-0079
–  When removing the hose on the master cylinder side, use the clutch circuit clamp (female) -SAT 1210- for the hose and the clutch circuit clamp (male) -SAT 1211- of the master cylinder.
–  Remove the lower trim of the driver's side footwell → Interior body work; Rep. Gr.68.
–  Remove clutch pedal → Chapter.
  E30-10004
–  Remove the bolt -arrow- securing the clutch pedal stop to the pedal bracket, according to the description.
  E30-0075
–  Remove the hexagonal nuts -arrows- and extract the pedal bracket -1- from the front panel.
–  Remove the master cylinder from the front panel.
  E30-0077

Remove and install bearing bracket and master cylinder|Installation > < Remove and install bearing bracket and master cylinder