Leon Mk2
| Cover for gearbox casing and 5th gear: Assembly overview |
| 1 - | Gearbox |
| q | Repairing → Chapter |
| 2 - | Sprocket of 5th gear |
| q | Fitting position: the collar should be orientated towards the gearbox casing cover → Item |
| q | removing and fitting → Chapter |
| 3 - | Circlip |
| q | replace |
| q | Determining thickness → Anchor |
| q | removing and fitting → Chapter |
| 4 - | Seal |
| q | replace |
| 5 - | Gearbox housing cover |
| q | removing and fitting → Chapter |
Note| If the gear housing cover is fitted while the gearbox is still in place, the oil level must be checked and when necessary, gear oil must be added → Chapter. |
| 6 - | Bolt |
| q | 5 Nm + further 1/4 (90°) |
| q | replace |
| 7 - | Circlip |
| q | replace |
| q | Determining thickness → Anchor |
| 8 - | Synchronising hub with locking collar and check ring for 5th gear |
| q | Dismantling and assembling → Chapter. |
| 9 - | Synchromesh ring of 5th gear: |
| 10 - | 5th gear mobile pinion |
| 11 - | Needle bearing |
| q | For 5th gear |
| 12 - | Selector fork for 5th gear |
| q | Dismantling and assembling → Chapter. |
| 13 - | Bearing pin |
| q | For the selector fork of 5th gear |
