Leon Mk2
| Clutch for vehicles with 1.4 l petrol engine: Assembly overview |
| 1 - | Dual-mass flywheel |
| q | Removing and installing → Rep. gr.13>>>>>>>> |
| q | Make sure that the centring pins have a tight fit. |
| q | Contact surface for clutch lining must be free of grooves, oil and grease |
| 2 - | Clutch plate |
| q | Assignment → Electronic parts catalogue „ETKA“ |
| q | Removing and installing → Chapter>>>>>>>> |
| q | Renew only together with SAC pressure plate. |
| q | Installation position: → Fig. |
| 3 - | SAC pressure plate |
| q | SAC means „self-adjusting clutch“. |
| q | Renew only together with clutch plate. |
| q | Assignment → Electronic parts catalogue „ETKA“ |
| q | Removing and installing → Chapter>>>>>>>> |
| q | Checking ends of diaphragm spring → Fig. |
| q | Checking spring connection and rivets → Fig. |
| q | From approx. 05.11: clutch release with additional plastic washer → Fig., clutch plate is adapted → Fig.. |
| 4 - | M6 bolt, 13 Nm, M7 bolt, 20 Nm |
| q | Loosen or tighten diagonally in small steps |
