seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Torque settings ?gearbox to engine? > < Removing gearbox, Alhambra 2011 ? with 1.4 litre petrol engine

Leon Mk2

Installing gearbox
Installing gearbox
Installation is carried out in reverse order. Nevertheless, important steps are listed here:
   
–  Examine needle bearing in crankshaft. If it is damaged or tarnished blue, it must be renewed → Rep. gr.13.
–  If it is not damaged, grease lightly with high-temperature grease -G052133A2-.
–  End of gearbox shaft (but not splines) also must be lightly greased.
–  Check for proper seating of both dowel sleeves between engine and gearbox.
–  Check for proper seating of intermediate plate.
  N34-10729
It must be possible to guide the engine and gear box together by hand until the flanges make contact all around.
If this is not so, then »something is wrong«!
–  Adjust the gearbox support until the engine and gearbox »align«.
  N01-0453
Pay attention to selector lever cable when raising gearbox. Insert the cable into the support bracket as soon as possible.
Cable must not be greased!
  N00-10244
–  Securing clips for selector lever cable must be renewed.
–  Adjusting the selector lever cable.
–  Check coolant level and top up if necessary → Rep. gr.19.
–  Check oil level and top up → Chapter.
Specified torques → Chapter
  N34-10721

Torque settings ?gearbox to engine? > < Removing gearbox, Alhambra 2011 ? with 1.4 litre petrol engine