seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Operation of the lever lock:checking > < Selector lever cable: removing and fitting|Fitting

Leon Mk2

Selector lever cable: verification and adjustment
Selector lever cable: verification and adjustment
Checking
–  Put the gear selector lever into position “P”.
   
–  Remove the selector lever cable from the selector rod shaft, by levering off -arrow-.
–  Change the gear selector lever from position “P” to “1”.
l  The gear actioning mechanism and the selector lever cable should move freely; if necessary, replace the selector lever cable or repair the gearbox actioning mechanism.
  Note
The safety washer of the selector lever on the gearbox counterhold should always be replaced once removed.
Adjusting
–  Put the gear selector lever into position “P”.
–  Move the selector rod shaft to “P”. The retaining lever should engage in the park locking gear, the two front wheel are locked (they cannot be turned together in one direction).
–  Clip the selector lever cable to the selector rod shaft.
  N37-0930
–  Tighten the bolt -arrow- 2 to 8 Nm.
–  Press the locking key on the knob of the selector lever and move the lever back 5 mm. Release the selector lever.
The selector lever should return to “P” by itself.
–  Place the selector lever in “N” pulling forwards and backwards 5 mm (check the same as for “P”).
The selector lever should return to “N” by itself.
Where necessary, repeat the adjustment again and repair the gear change mechanism.
  N37-0991

Operation of the lever lock:checking > < Selector lever cable: removing and fitting|Fitting