Leon Mk2
| I - Removing and installing ATF pump to supporting tube |
| Overview → Chapter |
| Dismantling planetary gearbox → Chapter, |
| Assembling → Chapter. |
| 1 - | Bolt |
| q | Qty. 7. |
| q | Tightening to 8 Nm and turning 90° further. |
| q | The turning further of 90° may be done in several stages. |
| q | Always renewing. |
| 2 - | ATF pump with -B2- piston |
| q | Replacement parts are allocated according to gearbox code letters. |
| q | Dismantling and assembling → Chapter. |
| 3 - | O-ring |
| q | Always renewing. |
| q | Placing on ATF pump. |
| 4 - | Seal |
| q | Always renewing. |
| 5 - | Spring cap, qty. 6 |
| q | Installing 3 spring caps after installing first outer disc. |
| q | Installing 3 spring caps before installing last outer disc. |
| 6 - | Spring |
| q | Qty. 3. |
| 7 - | Retaining ring |
| q | Not installed in gearboxes CYF, DAH. |
| 8 - | Shim |
| q | Not installed in gearboxes CYF, DAH. |
| 9 - | Corrugated washer |
| q | Only installed in gearboxes CYF, DAH. |
| 10 - | Outer disc -B2- |
| q | Quantity → Chapter. |
| q | Thickness of outer disc for adjusting -B2- must only be measured in gearboxes with installed corrugated washer → Item → Chapter „Adjusting 2nd and 4th gear brake -B2-“. |
| 11 - | Inner disc -B2- |
| q | Quantity → Chapter. |
| q | Before installing place new inner discs in ATF for 15 minutes. |
| 12 - | Outer disc -B2- |
| q | Always installing 2 mm thick outer discs. |
| q | Quantity → Chapter. |
| 13 - | Outer disc -B2- |
| q | Fitting 3 mm thick outer disc to supporting tube. |
| 14 - | Supporting tube -B2- |
| q | For disc pack of -B2-. |
| q | Inserting so that notch locates on freewheel wedge. |
| q | Replacement parts are allocated according to gearbox code letters. |
| 15 - | Gearbox housing with clutches installed |
| 16 - | Strainer |
| q | Only present from gearbox date of manufacture 14 02 0. |
