Leon Mk2
| II - Removing and installing reverse clutch -K2- to large sun gear |
| Overview → Chapter |
| Dismantling planetary gearbox → Chapter, |
| Assembling → Chapter. |
| 1 - | Reverse gear clutch -K2- |
| q | Dismantling and assembling → Chapter. |
| 2 - | Shim |
| q | Determining thickness → Chapter „Adjusting clutch play between -K1- and -K2-“. |
| q | 1 or 2 shims can be installed. |
| 3 - | 1st to 3rd gear clutch -K1- |
| q | Replacement parts are allocated according to gearbox code letters. |
| q | Clutches -K1- and -K3- can be pressed together in some gearboxes. |
| q | Pressing -K1- off -K3- → Chapter. |
| q | Dismantling and assembling → Chapter. |
| q | Pressing -K1- onto -K3- → Chapter |
| 4 - | O-ring |
| q | Always renewing. |
| 5 - | 3rd and 4th gear clutch -K3- with turbine shaft |
| q | Replacement parts are allocated according to gearbox code letters. |
| q | Clutches -K1- and -K3- can be pressed together in some gearboxes. |
| q | Pressing -K1- off -K3- → Chapter. |
| q | Dismantling and assembling → Chapter. |
| q | Pressing -K1- onto -K3- → Chapter |
| q | There are two different types → Chapter. |
| 6 - | Axial needle bearing with washer |
| q | Axial needle bearing faces towards small input shaft. |
| 7 - | Small input shaft |
| 8 - | Needle bearing |
| 9 - | Axial needle bearing |
| 10 - | Large input shaft |
| 11 - | Axial needle bearing |
| 12 - | Axial needle bearing washer |
| q | With shoulder. |
| 13 - | Large sun gear |
| 14 - | Axial needle bearing |
| 15 - | Axial needle bearing washer |
| 16 - | Gearbox housing with freewheel and circlips installed |
