SEAT Workshop Service and Repair Manuals

Installing

–  Insert solenoid -4- at an angle from the front between its holder and locking lever. Locking lever -1- must be pulled out of selector mechanism up to stop when doing this. –  Turn solenoid -4- to rear -arrow 3-. Then push solenoid -4- onto stop in its holder of selector mechanism. –  Push locking lever -1- into selector mechanism -arrow 2- as far as stop.

–  Push locking lever -1- past recess of selector lever housing -3- onto stop in selector mechanism -arrow 2-. –  Swivel locking lever down in this position -arrow 4-.

–  Swivel push rod -1- of solenoid -2- in direction of arrow into locking lever.

–  Insert retaining plate -2- and tighten bolts -1- firmly → Item - bolt.

–  Place selector lever housing onto selector mechanism and tighten bolts -arrows 1- firmly → Item - Torx screw. –  Tighten bolt -arrow 2- → Item - bolt.

–  Push cable -2- of solenoid into holders of selector mechanism -arrows-. –  Insert plug -1- of solenoid into side of holder of selector mechanism.