seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Adjusting sliding/tilting sunroof panel > < Installing sliding/tilting sunroof glass panel

Leon Mk2

Cover in the zero position
Cover in the zero position
   
The guide pin -1- must be aligned with the marking -arrow- on the left and right connecting member.
If this is not the case, adjust parallel running → Chapter.
–  Insert the glass cover of the sunroof from above and tighten the fastening bolts.
  N60-0209
–  Gently tighten the fastening bolts -arrows-.
–  Adjust rear of sunroof glass cover → Chapter
  Note
Tighten the securing bolts after adjusting the cover height to 4.5 Nm.
  N60-0206

Adjusting sliding/tilting sunroof panel > < Installing sliding/tilting sunroof glass panel