Leon Mk2
| Adjusting height |
Note| t | The threaded plate -6- for the striker pin is welded to the pillar. The webs of the threaded plate can be bent if sufficient force is applied. |
| t | It must be ensured that the striker pin does not cause the sliding door to be lifted or pressed down. |
| t | The locking element on the threaded bolt -2- and the hexagon nut -3- of the hinge fitting -1- does not need to be renewed. |
| t | Turning the threaded bolt -2- changes the height by 1 mm. Right turn for up, left turn for down |
| t | When the sliding door is being opened, special attention must be paid to the free movement of the seal or trim strip of the side window -arrow c- |
| t | Make sure that the arresters can run free. |
| – | In order to adjust the front sliding door vertically -9--arrow a-, the screws of the locking pegs must be loosened → Chapter |
| – | Undo the screws -8- of lower roller guide -7-. |
| – | Adjust the sliding door vertically -arrow a-. |
| – | Tighten the screws -8- of lower roller guide, tightening torque: 20 Nm. |
| – | Tighten screws of locking pegs securely → Chapter |
| – | In order to adjust the height -arrow b- of the rear sliding door-9-, the bolts -5- of the striker pin must be loosened -4-. |
| – | Loosen nut -3- on the hinge fitting -1- and adjust sliding door height -arrow b- using bolt -2-. |
| – | Tighten the nut -3- on the hinge fitting -1- using 18 mm tool insert -T10464-, tightening torque: 40 Nm. |
| – | Tighten the bolts of the striker pin, tightening torque: 20 Nm. |
| – | Check the adjustment. |
