seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Sunroof drive motor - removing and fitting > < Glass cover for the sunroof - adjusting

Leon Mk2

Removing and installing interior seal
Removing and installing interior seal
Special tools and workshop equipment required
   
t  Lever -U30800-
  W00-2169
t  Adhesive strip remover -VAS 6349-
  W00-10390
Removing
–  Remove glass cover → Chapter.
–  Loosen the seal -1- of the fitting frame -2- using the lever -U30800-.
  Note
Remove any possible adhesive residues on the frame using the Adhesive strip remover -VAS 6349- and clean the surface using the adhesive remover -D 002 000 10-.
  E60-10033
Installing
When installing, note the following:
–  Align the inner seal -1- in such a way that joining point aligns with the centre of the cover trim.
–  Remove the backing paper -2- from the gluing strip for the new -1- sticker.
–  Apply the seal to the dimensions as shown in the diagram.

   

Sunroof drive motor - removing and fitting > < Glass cover for the sunroof - adjusting