seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Lever for the rear seat bench longitudinal adjustment: Removing and installing > < Movable seat: Removing and installing

Leon Mk2

Adjustment trim for rear seat back: Removing and installing
Adjustment trim for rear seat back: Removing and installing
t  Removing: → Anchor
t  Installing: → Anchor
  Note
The following sequences described for the removal and installation apply for the trim on the left side of the part. The procedures of the removal and installation of the right trim on the left side of the rear seat as well as both trims of the right part are carried out in the same way.
Removing
–  Push the respective part of the rear seat to the front as far as possible.
   
–  Unscrew the screws -3- and loosen the trim for seat backrest -2- from the fitting.
–  Remove the pull loops -1- for releasing the backrest from the trim.

Installing
Installation is carried out in reverse order. The following should be taken into account:
–  Tighten bolt -3- to torque of 2.1 Nm.
   

Lever for the rear seat bench longitudinal adjustment: Removing and installing > < Movable seat: Removing and installing