seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Covers and padding for movable seat: Removing and installing > < Upholstery and padding for rear seats: Assembly overview

Leon Mk2

Seat covers and padding: Removing and installing
Seat covers and padding: Removing and installing
  Note
The following sequences described for the removal and installation apply for the rear seat bench on the left side. The procedures for the right-hand side are similar.
t  Removing: → Anchor
t  Installing: → Anchor
   
Special tools and workshop equipment required
t  Lever -T20043-
t  pressure tool -T20069-
t  Lever -U-30800-

   
Removing
  Note
During removal and assembly use the lever -T20043- and the lever -U 30800-.
–  Remove the rear seats → Chapter, → Chapter.
–  Unscrew the bolt -4-.
–  Remove seat side trim -5-.
–  Unhook retaining channel -2- from the seat frame -7-.
–  Detach the seat padding clips -3- from the seat cover -1- using the pressure tool -T20069-.

Installing
Installation is carried out in reverse order. The following should be taken into account:
  Note
To ease installation, we recommend heating the upholstery to approximately 30 ºC before fitting.
–  Tighten bolt -4- to 2.1 ± 0.2 Nm.
   

Covers and padding for movable seat: Removing and installing > < Upholstery and padding for rear seats: Assembly overview