SEAT Workshop Service and Repair Manuals

Special tools, workshop equipment, testers, measuring instruments and auxiliary items required

• ◆ Test box V.A.G 1598/31
• ◆ Hand multimeter V.A.G 1526 or multimeter V.A.G 1715
• ◆ Adapter set V.A.G 1594
• ◆ Current flow diagram

Test conditions

• ● The battery voltage must be at least 11.5 V.

Test sequence

• ‒ → Pull 3 pin connector -1- off Hall sender -2-.
• ‒ Connect multimeter to measure voltage using aux. cables from V.A.G 1594 to the outer contacts of the connector.
• ‒ Switch on ignition.
      Specification: min. 4.5 V
• ‒ Switch off ignition.

If no voltage is present:

• ‒ Remove battery.

• ‒ → Connect test box V.A.G 1598/31 to control unit wiring harness. The engine control unit remains disconnected.

• ‒ → Check wiring for open circuit between test box and connector using current flow diagram.
      Contact 1+socket 98
      Contact 2+socket 86
      Contact 3+socket 108
      Wire resistance: Max. 1.5 ω
• ‒ Additionally check wires for short to one another.

If no wiring fault is detected and voltage was present between contacts 1+3:

• ‒ Renew Hall sender (G40).

If no wiring fault is detected and no voltage was present between contacts 1+3:

• ‒ Renew engine control unit .