seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Removing and installing air duct connection for glove box cooling > < Removing and installing operating and display unit ( Climatronic control unit J255 )

Leon Mk2

Removing and installing operating and display unit (Climatronic control unitJ255)
Removing and installing operating and display unit (Climatronic control unit -J255-)
Removal
t  Removal on vehicles with no radio navigation system or radio with large control panel
   
–  Reach from underneath into centre console and release operating and display unit, Climatronic control unit -J255- from centre console.
  Note
If operating and display unit, Climatronic control unit -J255- cannot be removed, proceed as for vehicles with radio navigation system.
t  Removal on vehicles with radio navigation system or radio with large control panel
–  Remove radio or radio navigation system → Radio, telephone, navigation; Rep. Gr.91.
–  Reach through this opening and slide operating and display unit, Climatronic control unit -J255- to rear out of centre console.
  Note
t  The operating and display unit, Climatronic control unit -J255- is held in position in the centre console by way of 4 clips -A-.
t  In the event of incorrect dash panel temperature sensor -G56- measurements, check intake grille of operating and display unit, Climatronic control unit -J255- trim panel (must not be closed off) as well as operation of temperature sensor blower -V42-.
t  On replacing operating and display unit, Climatronic control unit -J255-, pay attention to precise assignment (e.g. without or with heated seat switch) → Spare parts catalogue.
  A87-0420
t  Operating and display units, Climatronic control unit -J255- for vehicles with no radio navigation system -A- are additionally provided with a trim panel -B- with 2 bolts -C-.
  A87-0421
–  Release connectors -A- to -D- and -F- by pressing retainer tabs and unplug connectors.
–  Screw out bolts -C-, slide trim panel -B- to right and detach it from operating and display unit, Climatronic control unit -J255--A-.
–  Install in reverse order.
  A87-0391

Removing and installing air duct connection for glove box cooling > < Removing and installing operating and display unit ( Climatronic control unit J255 )