seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Left temperature flap control motorV158 with potentiometer for left temperature flap control motorG220: Removing and installing. > < Central flap control motorV70 with potentiometer for central flap control motorG112: Removing and installing.

Leon Mk2

Defroster flap control motorV107 with potentiometer for defroster flap control motorG135: Removing and installing.
Defroster flap control motor -V107- with potentiometer for defroster flap control motor -G135-: Removing and installing.
Removal:
–  Disconnect battery → Electrical system; Rep. gr.27.
–  Remove the bottom section of the steering wheel housing according to the version of the model → Bodywork, interior fitting work; Rep. gr.68.
   
–  Remove the driver side footwell trim → Bodywork, interior fitting work; Rep. gr.68.
–  Remove the vent from the foot well area on the left side → Chapter.
  Note
The dash panel insert is not illustrated in the figure to provide a better overview of the parts to be removed.
  E87-10073
–  Remove bracket for fixing the tunnel -B-, remove the dash panel insert → Bodywork, interior fitting work; Rep. gr.70
–  Remove the Data bus diagnostic interface -J533--1- → Electrical system; Rep. gr. 27
  E80-10031
–  Remove bracket -A- from the Data bus diagnostic interface -J533- in the dash panel insert → Bodywork, interior fitting work; Rep. gr.70
–  Remove bolts -A-.
–  Release lever -D- and press the tabs -E- together.
–  Detach the connector -C- of the defroster flap control motor -V107-.
–  Detach control motor -B-.
Installation
  Note
  E87-10084
The lever -E- on the servomotor and the connecting rod -D- are colour coded. These are blue on the defroster flap control motor -V107-.
Re-install all parts removed in reverse order; note the following:
–  Route wiring harness so that it cannot come into contact with moving components (e.g. control motor lever).
  Note
t  All cable ties and other electric wiring harness fasteners released or severed when removing the air conditioner unit are to be re-attached in the same position on fitting.
t  Use the respective tightening torques.
–  Consult the fault memory of the Climatronic control unit -J255- and erase the faults that appear → Vehicle diagnostic tester.
–  Carry out the basic adjustment and diagnostic of the air conditioning actuators the consult the fault memory once again → Vehicle diagnostic tester.
  A87-0710

Left temperature flap control motorV158 with potentiometer for left temperature flap control motorG220: Removing and installing. > < Central flap control motorV70 with potentiometer for central flap control motorG112: Removing and installing.