Leon Mk2
| 2nd evaporator housing for rear seats |
| 1 - | Housing for heating and ventilation for rear seats, intake side |
| q | Assemble with clips |
| 2 - | 2nd evaporator |
| q | Installing seal on evaporator → Fig. |
| q | Do not dismantle further |
| 3 - | Bolt |
| q | 7 Nm |
| 4 - | O-ring |
| q | 11.1 mm; 1.82 mm |
| 5 - | O-ring |
| q | 14.0 mm; 1.82 mm |
| 6 - | Expansion valve for rear evaporator |
| q | Aperture must be sealed against splashed water. |
| q | The same component as for the front evaporator |
| 7 - | O-ring |
| q | 8.13 mm; 1.78 mm |
| 8 - | O-ring |
| q | 17.2 mm; 1.78 mm |
| 9 - | Seal |
| 10 - | O-rings |
| q | 14 mm; 1.78 mm |
| 11 - | O-rings |
| q | 8.13 mm; 1.78 mm |
| 12 - | Radiator fan control unit -J293- |
| 13 - | Rear fresh air blower -V80- |
| 14 - | Coolant hose |
| 15 - | Lip valve |
| 16 - | Housing for heating and ventilation for passenger compartment, vent side |
| q | Assemble with clips |
| 17 - | Rear temperature flap control motor -V137- |
| 18 - | Rear air distribution control motor -V136- |
| 19 - | Air distribution flap |
| 20 - | Heat exchanger for rear seats |
| q | Installing seal on heat exchanger → Fig. |
| 21 - | Temperature flap for passenger compartment |
|
|
|
|
