seat Workshop Repair Guides

SEAT Workshop Service and Repair Manuals

ABOUT US
Clutch pedal: removing and refitting > < Refitting (Clutch cable tensioned)

Leon Mk2

Refitting (Clutch cable untensioned)
Refitting (Clutch cable untensioned)
–  Lubricate with -MoS2- grease where the end of the clutch cable fits into the clutch pedal.
–  Pass the clutch cable through the dashboard and fit the bellows.
   
–  Attach the cable to the clutch pedal -arrow-.
  V30-0397
–  Fit the fixing tape -A-.
–  Pull the end of the cable in the -direction of the arrow 1- and hold. At the same time move the cable cover with the readjustment mechanism -B- several times from one side to the other until it can be compressed towards the dashboard (-direction of the arrow 2-).
  E30-0017
–  Fit the ends of the fixing tape to the two bolts (-arrows-) of the readjustment mechanism (2nd mechanic).
–  Fit the bellows in the dashboard.
–  Fit the rubber stop to the gearbox support.
–  Fit the clutch cable in the declutching lever.
  V30-0433
–  Fit the clutch cable in the supports -arrows-.
  N30-0168
–  Remove the fixing tape after fitting the clutch cable -arrows-.
–  Make sure that the clutch cable works properly → Chapter.
  N30-0136

Clutch pedal: removing and refitting > < Refitting (Clutch cable tensioned)